#Keymod rail section for vertical grip install#
#Keymod rail section for vertical grip full#
#Keymod rail section for vertical grip pro#
#Keymod rail section for vertical grip free#

That 30 degrees (or so) will now be retightened against the lockring with the strap wrench. Play around backing off the HG about another 30 degrees further from rail alignment, then tighten the lock ring forward against the HG snug. This is where you use your 'estimation'. There will be a small gap (mm+) between HG and upper continuous rail. I found out you'll have problems with tolerances around your takedown pin space.

Do not thread HG against upper receiver, even if it fits perfect.

#Keymod rail section for vertical grip full#

Screw the handguard lock ring (threaded outside the bbl nut) full rearward toward the upper receiver to keep out of the way during HG install. I used 1 drop blue loctite on handguard threads. Handguard screws on to barrel nut (lots of threads). Remove the handguard set screw at the bottom rear rail.

#Keymod rail section for vertical grip install#

Install barrel nut/gas block&tube according to standard rules You will need a strap wrench (cloth one is best). So I thought to mention that (I have to remove 4 crush washers - my poor planning). THESE MUST BE INSTALLED BEFORE THE MUZZLE. They attach to the open end of the rail with 4 tapered screws (to prevent things from getting into the handguard area - if you desire), and the caps have 2 small set screw against the barrel. If you want them, ohhunts makes and sells them too.

#Keymod rail section for vertical grip free#

Mid $300's for 10 free float handguards.Д«ear in mind these are set up to receive the rail end caps.

But the tubes all passed through and everything seats fine. The ONLY thing I found was a slight variance in the HEIGHT of the gas tube holes when torquing (the gas tube would tap the receiver entrance on the top side (I have a cheap flex video scope). Only thing is there is no instruction - though I watched an identical handguard install online (same mfr I presume). Finding these was an unexpected surprise.

#Keymod rail section for vertical grip pro#

I had inadvertently bought barrels with dedicated pinned low pro gas blocks, making free float a necessity. I think they may just keep these, unless very particular. Trying to keep the investment as small as possible (when sold, new owners will customize every part to their favor). The price for these rails is outstanding. At the time of this review I have all the ohhunt barrel nuts installed and 4 of the handguards. The term 'public place' means an area open to the public or exposed to public view and includes streets, sidewalks, bridges, alleys, plazas, parks, driveways, parking lots, automobiles, whether moving or not, and buildings open to the general public, including those that serve food or drink, or provide entertainment, and the doorways and entrances to buildings or dwellings and the grounds enclosing them.ДЄny person who changes, alters, removes, or obliterates any coloration or markings that are required for by any applicable state or federal law or regulation, for any imitation firearm (replica firearm), or device in any way that makes the imitation firearm (replica firearm) or device look more like a firearm is guilty of violating the state or federal law.Д«y accessing the Site, you certify that you are older than 18 years of age or the age of majority where you live, whichever is older that you are the owner of any credit card used to purchase on items on the Site that you are familiar with all local laws in your area affecting your legal right to access airsoft products that any products you buy are for your own private enjoyment and that you will NEVER share these products with a minor in ANY WAY.South Georgia & South Sandwich Islands (USD $) No person may openly display or expose any imitation firearm (replica firearm), in a public place. All airsoft guns are required to have the tip (1/4 inch) of the barrel permanently colored in blaze orange.